Most motorists are ignored and believe that the washer of the windshield is just a secondary device, the breakdown of which will not affect the general state of the car. But, such an opinion is wrong.
Take, for example, raw or rainy weather, from under the wheels of passing vehicles especially buses or trucks, windshield can easily be sprayed with dirty water accumulated on the roads. It is extremely dangerous to. The result of all of the above will be that the washer of the windshield is responsible not only for the comfortable movement by car, but also for its safety.
The reasons for the fault of the main glass washer
Before considering the most common breakdowns of washerers, the reasons for their manifestation, as well as possible elimination options, it should be mentioned that not always when the washer breakdown, water will not pour on the windshield. The reason for this may simply consist in the finished liquid in his tank, which occasionally needs to be added.
The most common causes of breakdown is the clogged filter on the windshield washer of the windshield located in a liquid tank or also clogged nozzles on nozzles. In order to eliminate such a breakdown, it is necessary to remove the pump itself from the tank to begin to remove the pump itself, after which we disconnect the filter elements from it, then thoroughly washed them under running water and blow out with compressed air. The same actions are carried out with the jacklers of spraying nozzles of the system.
Then you need to check if the pump motor works. To do this, you need to turn on the washer, if the motor has earned, then the system is connected correctly, if not, then it is not serviceable or not correctly connected. In the case of its non -service, the car should be shown an electrician to find out the cause of the non -working motor.
Also, a malfunction of the windshield washer may consist in impaired tightness and the connection of the hoses. The first step in this case will be a sequential examination of all hoses to fluid lending. If the course of the hose is detected, it should be replaced if the liquid leaks at the junction, then you need to compress it with special tools, until the leak is eliminated.
Be sure after each repairs, the tank must be freed from the remaining liquid, cleaned from precipitation and dirt and fill with new liquid. You should also not forget about the fact that if you used water in the system for a warm period, with the advent of the cold, it will need to be drained, and the barrel should be seasoned with an anti -target, which allows the use of washers even at low temperatures.
After the nozzle jet was cleaned, you should not forget about their configuration, which differs depending on the nozzle model. As a rule, in non -expensive nozzles, the angle is rebuilt using an awl or needle. Having inserted one or another device into the hole of the nozzle, raise and lower it until the jet of the liquid falls up the windshield. This is necessary, because when the car is movement, the flow of oncoming air will bend the stream and, as a result of which, it does not fall on the entire surface of the glass, but only on its lower part.
More expensive models are distinguished by the presence of an adjusting screw. There are also nozzles with special nozzles that produce more than one stream, but sprinkle the liquid over the entire surface of the windshield. Lobe glass washer veinist is referring to this type of washer
A brief resume
Feeling our recommendations said, you avoid from unwanted consequences when moving with dirty windshield. Any of the troubles is best identified and eliminated in a timely manner, due to the fact that over time it can aggravate the condition of both the washer itself and the car as a whole.