Plastic windows are a well -known means of combating cold and lose heat. Each owner tries to save heat in the house, and according to statistics, it is from 40 to 50% heat that is lost through door and window openings. Control over the production of plastic windows, very hard. All stages of production, from the manufacture of double -glazed windows to the final assembly of the windows are controlled by the quality control authorities. And then the windows pass into the hands of selling companies, and later to the buyer. Here, control is lost and is lost. But the installation of plastic windows, no matter how qualitatively they are made, requires no less tight control. That is why, do not trust the installation of plastic windows amateurs.
The company that will install windows must have all permitting documents, certificates, license. Of course, it is best if the manufacturer is installed by the manufacturer, for example, the Euro -Office company, which not only produces, but also sets plastic windows in Ryazan, Voronezh, Moscow and many more cities of Russia. But if you have not found such a company in your city, then your presence and control over the process of installing windows is an integral part of the process.
Installation Requirements: First of all, it is worth remembering that the correct installation of a plastic window depends on the sealing of the outer seams between the frame and the wall. It should be noted that the gap between the window frame and the wall needs to leave the gaps of at least 2-3cm. Foam plays not only the role of filling and fasteners, but also plays the role of a shock absorber. In no case, it is not allowed to install the window on the bars or any spacers. After all, if the window plays, then it will fall into the foam, and not in the bars. It is important that the inter -ceiling mount was not fixed very hard. It is also necessary to monitor the installation of the window by level, both vertically and horizontally. Construct it yourself, look into the level of the level. It is necessary, together with the installation of the window, to install the windowsill and tide from the outside. Do not delay the installation of castings, otherwise the water will fall into the foam and penetrate under the frame. The mounting foam always goes beyond the seams, after its excess is completely dried, it is necessary to remove. It is worth knowing that it must be cut a little deeper than the window frame, so that the solution with which you will subsequently close the external seams hold well and does not fall off. Painting, or suture plaster is necessary, otherwise the mounting foam will be destroyed from weather conditions. It is the sun that has a strong effect on foam.
When concluding an agreement on the purchase and manufacture of a window, it is necessary to indicate whether the company will install the window to install the window. You need to discuss all terms and prices in advance. Prices for the installation of windows can be from 10 to 20% of the total window cost. A little more expensive the price when installing windows on the upper floors in high -rise buildings.